our products

Tile Carts

 3- point hitches:  Category 2, Category 3 narrow, & Category 3 wide

  •  Main frame construction: 4” x 6” x ¼” steel tubing

  • 4 ½” spindle with 10 bolt 20,000 pound hub to support the spindle

  • 11’ table with 24 spokes

  •  Main tile cart has 8” 7 gauge tower

pull type

  • Walking tandem axle

  • 4 ½” spindle with 10 bolt 20,000 pound hub to support the spindle

  • 11’ table with 24 spokes

pull type plows

5’ pull type plow

  • Maximum Cut 5’ - Pulls up to 8” Tile

6' Pull Type Plow

  • Maximum Cut 6' 2” - Pulls up to 12" Tile 

7  1/2'  Pull Type Plow

  • Maximum Cut 7' 6” - Pulls up to 12" Tile

3- Point Plow

made with 3"x14" Solid Grade 50 Steel Shank

Maximum Cut 5’ 3"         Pull up to 8” Tile

The 3-point design makes backing into your tile ditch easier and can be pulled with a smaller machine than some of our other designs.

  • When using this 3-Point Plow, put the tractor’s 3-point control at 12”-14” and shut the draft control off. 

  • The smaller cylinder is used to raise and lower the plow and runs on float while installing tile. 

  • The top, larger cylinder, is used to control plow depth.

  • If a Category 3 Quick Coupler is used, this plow can be mounted on the back of a smaller track machine because this plow has it’s own lift cylinder.

Frame mounted plow

6’ frame

  • Maximum Cut 7’ - Pulls up to 12” Tile

7 1/2’ frame

  • Maximum Cut 7' 6” - Pulls up to 12" Tile 

The ditch closer

This product fills in the ditch leaving small ridge for the dirt to naturally settle.  A tractor of at least 65 H.P. is needed to pull this machine.  The width can easily be adjusted from inside the tractor to accommodate the width of your ditches.

  • Arms adjust out to 8’  - Category 2 and/or 3 hitch  - 32” notched blades

  • 3” Hardened Steel Axles  -  8,000 lbs

  • Full Out:  Front 8’      Full In:  Back 2'